A-Yarubi, Qahtan and Lucas, Gary (2009) Measurement of the Film Thickness, Film Velocity and Entrainment Fraction in a Liquid-Air Annular Flow Using a Conductance Flowmeter. In: Conference of the International Journal of Arts & Sciences, 23-26 February 2009, Malta.
Abstract

In certain older oil wells in the Middle East, the produced fluid is predominantly natural gas which flows at very high rates (e.g.
50,000 m3 / day ). Smaller quantities of crude oil (e.g. 50m3 / day ) and water (950m3 / day ) are also produced. Given the relatively much higher flow rate of the gas the flow regime is annular with most of the liquid flowing in a thin film on the pipe wall. The annular flow regime makes measurement of the total liquid flow rate difficult. It is even more difficult
to measure the individual flow rate of either the oil or the water. In a vertical Perspex pipe (i.d. = 50 mm) using a newly-designed flow loop in the University of Huddersfield, annular flow was established and different measurements were carried out. At the first stage, only water-air annular flow was being used to investigate the possible measurement techniques to
achieve the aim of this study. The techniques in this study include the use of conductivity probes to measure the liquid film thickness and to obtain
the film velocity using the cross-correlation technique. The obtained
results were compared to previous work by Zabaras and Dukler for the
same pipe diameter. The results of the present work have shown a good
agreement with Zabaras and Dukler’s work which indicates the success of
the new measurement techniques.

Information
Library
Documents
[img]
Preview
Paper1st_Q_Al-Yarubi_G_Lucas.pdf - Published Version

Download (380kB) | Preview
Statistics

Downloads

Downloads per month over past year

Add to AnyAdd to TwitterAdd to FacebookAdd to LinkedinAdd to PinterestAdd to Email