Li, Hongyu, Walker, David D., Yu, Guoyu, Sayle, Andrew, Messelink, Wilhelmus, Evans, Rob and Beaucamp, Anthony (2013) Edge control in CNC polishing, paper 2: simulation and validation of tool influence functions on edges. Optics Express, 21 (1). pp. 370-381. ISSN 1094-4087
Abstract

Edge mis-figure is regarded as one of the most difficult technical issues for manufacturing the segments of extremely large telescopes, which
can dominate key aspects of performance. A novel edge-control technique has been developed, based on ‘Precessions’ polishing technique and for
which accurate and stable edge tool influence functions (TIFs) are crucial. In the first paper in this series [D. Walker Opt. Express 20, 19787–19798 (2012)], multiple parameters were experimentally optimized using an extended set of experiments. The first purpose of this new work is to ‘short circuit’ this procedure through modeling. This also gives the prospect of
optimizing local (as distinct from global) polishing for edge mis-figure, now under separate development. This paper presents a model that can
predict edge TIFs based on surface-speed profiles and pressure distributions over the polishing spot at the edge of the part, the latter calculated by finite element analysis and verified by direct force measurement. This paper also presents a hybrid-measurement method for edge TIFs to verify the simulation results. Experimental and simulation results show good agreement.

Information
Library
Statistics
Add to AnyAdd to TwitterAdd to FacebookAdd to LinkedinAdd to PinterestAdd to Email